Publicité
Les langues disponibles
Les langues disponibles
If planning to attach the 225W or 226W hutches to either the 223W or 224W bases, please
read the following. There are two methods for attaching the hutch.
R
x 4
223W Base Top
225W Hutch
FIG. 10
METHOD 1:
To remove the top from the Base unit: Remove the screws that attach the Backs to the Top.
Loosen the Rafix Cams on each side panel and remove the Top from the unit. Locate the unused
holes in the underside of the Top. See Base instructions for correct position. These will be the holes
that do not have the Rafix Bolts already installed. Using a 3/16" drill bit, drill out the holes to the
other side.
Lay the assembled hutch on its back and align the sides of the hutch flush to the outer edges and
back of the base unit top. Attach the hutch and base using four Black Screws (R) from the hutch kit.
See FIGURE 10. Lift the entire hutch with attached base top and replace it on the body of the base.
Retighten the Rafix Cams and reattach the back with Screws.
L
K
x 4
METHOD 2:
Optional: Place Pads (L) in each corner on the bottom of the hutch
side panels where they will come in contact with the base unit.
Use the Mending Plates provided with the hutch. To do so, remove
the two outer screws that hold the back to the hutch. See FIGURE 11
for correct location. Reattach the screws adding the brass mending
plate provided. As shown in FIGURE 11 angle the mending plates
out at a 45-degree angle. Align the hole on the other end of the
mending plate so that it is centered on top shelf of the base. Attach
the mending plate to the base top using Screws (K).
All manuals and user guides at all-guides.com
x 2
O
x 2
NOTE:
R
R
224W Base Top
K
FIG. 11
O
45°
R
R
K
O
45°
Publicité
