ARIETE TORNADO Mode D'emploi page 11

WARNING: Never use the vacuum cleaner if any filter is missing or damaged. Any dust cleaned up
will enter the appliance and damage the motor.
WARNING: Clean the filters regularly or in any case, whenever the suction power seems to be
reduced.
Emptying the dust container (5)
The transparent surface of the dust container makes it easy to see when it needs to be emptied, or
you can wait until the relevant indicator light (3) switches on.
s Press the release button (7) and at the same time, remove the dust container (5) using the rels s
evant handle (6) (Fig. 6).
s Empty the dust from the container (5) by opening the lid by pressing down on the release button
(Fig. 7).
s To clean out the container (5) thoroughly, remove the filter (8), turning it anticlockwise and pulling
it outwards (Fig. 8).
CAUTION: Only wash the filter using clean water; never use soap or detergent.
s To refit the filter (8), place it inside the container (5) and turn it clockwise.
s Refit the dust container (5) onto the body of the appliance so that it clicks into place.
IMPORTANT: When the dust container becomes full, it is advisable to place a plastic bag over the
top and empty it inside the bag itself to prevent dust and dirt from leaking out.
Cleaning the motor filter
The motor filter and its special covering need to be cleaned on a regular basis.
s Use the lever and lower the hatch in the back part of the appliance (Fig. 9).
s Remove the filter and clean it under running water (Fig. 10). Leave it to dry thoroughly.
s Refit the filter and click the hatch shut.
WARNING: Only wash the filter in clean water, without using soap or detergents.
WARNING: This operation is necessary at least once every 6 months or in any case, when suction
power is notably reduced.
Cleaning the vacuum cleaner
The casing, dust container and filter seats can be wiped with a damp cloth if necessary. No liquid
must enter the vacuum cleaner in the process. Never use heavysduty cleaning substances (stain
removers, thinners) because they can corrode the plastic surfaces. Only put the plug back into the
mains socket when you are sure that all parts are thoroughly dry.
IMPORTANT: Do not lubricate or oil any rotating parts, since this could cause dirt and fluff to stick
even further
Cleaning the brushes
While the appliance is switched on, move your hand between the bristles on the brush to free them
of any trapped dust, which will then be sucked into the cleaner.
Downloaded From Vacuum-Manual.com Manuals
All manuals and user guides at all-guides.com
s 9 s
EN