Stiebel Eltron Ultronic-1 Plus Mode D'emploi page 15

INSTALLATION
Installation
Connect the power cable to the mains terminal according to
the markings.
Lay the power cable in the cable duct.
2
1
1 Cable exit
2 Strain relief fittings
If the power cable is routed through the cable exit, route the
connecting cable through the 3 integral strain reliefs on the
back of the wall mounting bracket.
www.stiebel-eltron-usa.com
Secure the wall mounting bracket to the wall with the provid-
ed screws.
Secure the cable cover to the wall mounting bracket.
11.3 Opening the appliance
Remove the casing cover to insert the HEPA filter or to set the
appliance functions.
If you want to start the appliance directly, you can continue the
installation by following the chapter "Installing the appliance".
™
Ultronic Plus
5 Phillips screws
Use a suitable screwdriver to unscrew the Phillips screws on
the back of the appliance.
™
Ultronic Plus & Premium Hand Dryers |
™
Ultronic Premium
5 Phillips screws - 4 casing, 1 ground
15