Cameo ROOT PAR TW Manuel D'utilisation page 12

Setup example:
Set the DMX delay for DMX operating modes with DMX delay channel (D2CH, D3CH,
D4CH1, D4CH2, D8CH): Starting from the main display, press MENU to go to the main menu.
Using the and buttons, now select the DMX Delay menu option and press ENTER twice to
confirm your selection.
Assign the spotlight to one of 95 groups (maximum number of groups depending on the activated
DMX mode). Several spotlights can also be assigned to one group. The group number is also the
factor by which the set delay time is multiplied. Confirm each entry via ENTER.
The delay time (delay time of the DMX signal) is set using a DMX controller in the separate DMX
delay channel of the corresponding DMX operating mode (0.0s to 2.0s in 0.1s steps).
Setup example:
STAND-ALONE MODE DIRECT
As with a DMX control device, stand-alone mode Direct makes it possible to directly set values
from 000 to 255 on the device for the dimmer, strobe, cold white, and warm white. This allows the
user to create individual scenes without needing an additional DMX controller.
12