Publicité
Les langues disponibles
Les langues disponibles
WARNING: To reduce the risk of injury, user must
A
n0
Do not dispose this product with household rubbish
Li-Ion
TYPE
Voltage D.C. [V]
R.P.M.
Electronic speed control
Battery life [min]
Ø Orbit [mm]
Ø Backing Pad [mm]
Ø Backing Foam [mm]
Backing Pad Thread
Weight [Kg]
* The value is referred to a use of the battery pack 9HB180LT, fully charged with the charger 9HC180LT.
** measured without the functional units: battery pack or power supply.
CORRECT USAGE
• This tool is designed to be used as a polisher. Read all safety warnings, instructions, indications provided on
drawings and specifications provided with this tool. Failure to comply with all instructions provided below may cause
electrical shocks, fire and/or serious injuries.
• This tool is not intended to be used for smoothing, metal brushing and cutting operations. The use of this tool
for unintended applications may cause hazards and injuries to people.
• Air vents often cover moving parts and should be avoided. Loose clothes, jewellery or long hair can be
caught in moving parts.
• Clean out your tool often, especially after heavy use. Dust and grit containing metal particles often
accumulate on interior surfaces and could create an electric shock hazard.
• The tool must be used with accessories that have been specifically designed or recommended by the
manufacturer. The fixing of the accessory to the tool does not guarantee a safe operation.
• The rated speed of the accessories must be at least equivalent to the maximum speed specified on the
tool. Using the accessories at speeds above the rated one, may cause them to break or be projected into the air.
• The external diameter and thickness of the accessories must match the specifications of the tool.
Accessories with incorrect dimensions cannot be adequately protected or controlled.
• The configuration of accessories must match the tool. The use of accessories that cannot be perfectly fitted
on the tool may result in imbalance, excessive vibrations and in the impossibility of controlling the tool.
• Do not use damaged accessories. Before use, inspect all the accessories. Inspect the supporting pads
and verify there are no cracks, tears or excessive wear. If the tool or accessory has fallen, verify that it
is not damaged or install a new accessory. After inspecting or installing an accessory, test the operation
6
Summary of device labels containing safety information
read instruction manual
Wear ear protection
Wear eye protection
Ampere
No-load speed
Product contains Lithium-Ion.
TECHNICAL SPECIFICATIONS
CE mark for EU market
V
/min
Disposal of decommissioned
HLR75
18
3000÷5500
•
~45*
12
75
80-100
M6
1,1**
Wear gloves
Wear a mask
Volt Direct Current
Per minute
(WEEE Directive)
Publicité
