Troubleshooting - Hotpoint Ariston FK 1041L P.20 X-HA DS Mode D'emploi

Masquer les pouces

Table des Matières

Les langues disponibles

Programming delayed automatic cleaning

! Programming is possible only after selecting the cleaning cycle.

1. Press the

icon twice; the end of pyrolysis time will begin to flash.

2. Turn the control dial to adjust the end of pyrolysis time; hold the dial in this

position to scroll through the numbers more quickly and make the setting

process easier. The display will show a graphic indicating the delayed start

in bar format.

3. Once you have reached the desired end time, press the

The delayed start bar will show the current time, the time remaining until the

start of pyrolysis, the duration and the end of pyrolysis time as a graphic.

4. Press

to begin the pyrolysis schedule.

5. The display shows the remaining time, moving the delayed start bar

backwards.

6. Once pyrolysis has begun, the display will indicate the remaining time by

filling the duration bar.

7. When the time has elapsed, "CLEANING CYCLE FINISHED" appears on

the display and a buzzer sounds.

• For example: it is 9:00 a.m. and the Economy PYROLYTIC cycle has been

selected: default set time 1 hour. 12:30 is scheduled as the end time. The

programme will start automatically at 11:30 a.m.

To cancel a schedule, press the

Once the automatic cleaning cycle is over

Before you can open the oven door, you will have to wait for the

switch off: this indicates the oven temperature has dropped to an acceptable

level. You will notice some white dust deposits on the bottom and the sides

of your oven; remove these deposits with a damp sponge once the oven

has cooled down completely. Alternatively, you can make use of the already

heated oven, in which case it is not necessary to remove the deposits, they

are completely harmless and will not affect your food in any way.