Costway FP10040 Mode D'emploi page 13

• Grasp only the sides of the oven door. DO NOT grasp the handle
as it may swing in your hand and cause damage or injury.
• Failure to grasp the oven door firmly and properly could result is
personal injury or product damage.
• To avoid injury from hinge bracket snapping closed, be sure that
both levers are securely in place before removing the door. Also,
DO NOT force door open or closed. The hinge could be damaged
and injury could result.
Follow these instructions:
1. Open the door fully. (Refer to Figure 7.)
2. Lift up and push the small levers located on the two hinges all
the way back. (Refer to Figure 8.)
3. While holding the door on each side, shut the door until it
touches the levers. Then continue closing the door until it is about
4 inches (10cm) from being fully closed.
4. Pull the door towards you, pulling it out of its seat. The door will
gently come away from the oven. (Refer to Figure 9.)
5. To replace
the door,
perform the
reverse of the
above
procedure.
NOTE: If the door does not come
away from oven easily, DO NOT
force it.
24
Figure 7 Figure 8
Figure 9
REPLACING OVEN INTERIOR LIGHT
WARNING: Electrical Shock Hazard
Failure to follow these instructions can result in death, fire, or
electrical shock.
1. Disconnect the oven from the power supply by means of the
omni-polar switch used to connect the appliance to the electrical
mains, or unplug the appliance if the plug is accessible.
2. Remove the glass cover of the light bulb holder turning
counter-clockwise. (Refer to Figure 10.)
3. Replace the old light bulb with a new oven-safe light bulb with
the following characteristics:
• Voltage: 208-240V
• Wattage: 25W
• Type: E14
4. Put the glass cover back
and reconnect the oven to
the main power supply.
TRANSPORTING
WARNING: Electrical Shock Hazard
Failure to follow these instructions can result in death, fire, or
electrical shock.
1. Before moving your oven, or
performing maintenance,
disconnect it from the power
supply.
Figure 10
Figure 11
25