MINN KOTA MKA-60 Mode D'emploi page 4

5
n. After the Rod is cut, replace the Body of the
bracket on top of the Rod and secure it in place
with the Knob.
Clearance is built into the Body to fit the top of
NOTICE:
the Rod in an imperfect cut from the previous step.
o. To fine-tune the height of the Body, loosen the Nylon
Hex Nut at the base of the Rod. Once loose, rotate
the Rod in the Swivel Base in a clockwise direction
to lower it and in a counterclockwise direction to
raise it. Only use the adjustment at the bottom of
the Rod to fine-tune the height of the Rod to provide
adequate support. Test the placement with the motor
in the stowed position.
p. Rotate the Rod in place until it is the proper height to
provide adequate support for the Shaft. Then secure
the Rod by rotating the Nylon Hex Nut down until it is
tight against the Swivel Base.
6
q. To use the Bow-mount Stabilizer Bracket, engage the
Plunger and rotate the Swivel Base so that the Rod is
locked into position.
r. Rotate the Body so that the cradle aligns with the
motor Shaft. Stow the trolling motor and lower the
motor, so the Shaft is captured in the Body of the
bracket. Secure the Shaft by hooking the Rubber
Strap in place.
CAUTION
The Rubber Strap is only intended to capture the motor Shaft.
Do not constrict any wires routing out of the Control Head or
otherwise in the Rubber Strap when it is secured on the Bow
Mount Stabilizer Bracket.
For warranty information, please visit minnkota.johnsonoutdoors.com.
minnkota.johnsonoutdoors.com
Part #2377179
Minn Kota Consumer & Technical Service
Johnson Outdoors Marine Electronics, Inc.
PO Box 8129
Mankato, MN 56001
ECN 43845
5n
Rubber Rubber
Strap Strap
Knob Knob
5o
Swivel Base Swivel Base
Boat Deck Boat Deck
121 Power Drive
Mankato, MN 56001
Phone (800) 227-6433
Fax (800) 527-4464
Body Body
Rod Rod
Rod Rod
Nylon Hex Nylon Hex
Nut Nut
Rubber Strap Rubber Strap
Shaft Shaft
©2023 Johnson Outdoors Marine Electronics, Inc.
All rights reserved.
Rev B 05/23