BoomToneDJ Duo Roll LED Mode D'emploi page 13

Mode
Addr
ChNd
SLNd
ShNd
SenS
Led
diSP
teSt
Ver
rSet
5. How to control the fixture
There are two ways to control the fixture
A. Universal DMX controller
B. Master/Slave operation
A. Universal DMX controller
The fixture can be set the DMX address remotely by universal DMX controller. First, you
need to programming two scenes into a chase, and then link the fixtures to the universal
DMX controller. When you run the chase, all the fixtures of the chain will be set the series
DMX address automatically. The fixture uses four channels. Please refer to the following
diagram to set the address for the first four units.
B. Master/Slave operation
The fixture will allow you to link 16 fixtures together and operate without a controller. In
Operation mode
DMX address
DMX Channels
Master/Slave mode
Sound mode
Auto mode with speed
Sound Sensitivity
Black Light
Display Normal/Inversion
Auto Test
Software version
Reset
12
Mast
Slav
A512
A001-A512
1 Ch
8 Ch
NASt
SL 1
SL 2
Sh0 – Sh8
Auto-SP1-SP9
0 - 100
on
oFF
dSiP
teSt
V10