Niko 10-505 Mode D'emploi page 25

10-505
Action
find intercom
activate call forwarding
activate ring-and-come-in function
activate internal call
activate control function for DIN rail relay
connect intercom as slave to a master (parallel connection)
deactivate programming of master and slave
5.2. Setting the ring tone
The intercom can distinguish between calls from an external unit (door call), a floor call and a call from another internal unit (internal call). A
separate ring tone can be selected for each type of call. The device offers a selection of 13 different ring tones.
Step Action
1.
Press and hold
2. Press one of the following function keys several times:
• door call:
• floor call:
• internal call:
3. Wait 8 seconds.
5.3. Time settings
The default time settings for the intercom are:
Parameter
speech time from the start of the conversation
number of times the green indication LED will flash when the line is engaged
time during which the call at an external unit or a floor call remains signalled
time during which an internal call you made remains signalled
These settings can be changed via:
• the power supply (10-80X)
• the service set (10-870)
• the relay (10-83X)
Refer to the manual for device-specific instructions.
6. TROUBLESHOOTING
1. Using a multimeter, always first check the voltage between the terminals:
Between terminals ...
b and a
b and P
for 8 seconds.
Key combination
* 51 #
* 80 # serial number intercom # serial number internal unit for
forwarding #
* 81 # serial number intercom #
* 82 # serial number intercom # serial number internal unit to be
called #
* 83 # serial number intercom #
* 89 # serial number intercom # serial number master #
* 89 # serial number intercom # 0 #
Result
You will hear a beep tone and both indication LEDs will be
illuminated. The ring tone selection is activated.
You will go through a list of ring tones available for each type of
call. The latest ring tone that you selected will be stored in the
memory of the device.
You will hear a beep tone and both indication LEDs will no longer
be illuminated. The ring tone selection is deactivated.
Default setting
2 min
three times in 2 s
30 s
30 s
The following voltage must be present
+ 24 Vdc
+ 24 Vdc
22