Aiphone JK-1MED Manuel D'installation Et D'utilisation page 14

8-6 Pan/tilt operation
1
When a zoom picture is displayed, press , , , or  button.
• ［］: Up
• ［］: Down
• ［］: Left
• ［］: Right
• Moving diagonally is also possible.
8-7 Zoom Picture Pre-set
The picture can be set to display using a set zoom picture position
for when a call is received from the door station. When switching
from the wide picture to the zoom picture, the zoom picture displays
starting from the pre-set position.
1
When a zoom picture is displayed, press , , , or  button.
(Ex. Pressing  button moves the picture up.)
• While viewing the picture, set the desired picture position.
NOTES: 1. To change the zoom picture position that has been set, perform the
zoom position setting again. The previous setting will be overwritten.
2. The zoom picture position set with the master monitor station will
also be displayed at the sub monitor station.
8-8 Night illumination
At night, the door station Illuminator LED lights up during
calling or communication.
8-8-1
When a call is made from the door station
1
If CALL button of door station is pressed
2
When communication ends, the illuminator
LED will go out.
The Illuminator
LED lights up.
- 14 -
[Zoom picture]
The image range of the zoom picture and wide picture differs. The
edges of the wide picture do not display with the zoom picture.
2
Press ZOOM/WIDE button (for at least 2 seconds).
• A beep will sound and the position setting will be completed.
8-8-2
Light up the Illuminator LED during entrance
monitoring
1
When TALK button is pressed during entrance
monitoring, communication starts and the
Illuminator LED will light up.
• Inside sound can be heard at the entrance.
Communication starts at this time, so be
aware that inside sound can be heard at
the entrance.
2
When communication ends, the illuminator LED will go out.
NOTES: Distinguishing between day and night is automatically
done by the door station.