GE Spacemaker WSM27TH Guide De L'utilisation page 10

Dryer Operating
Steps
All manuals and user guides at all-guides.com
To reduce the risk of fire, electrical shock, or injury to
persons, read the IMPORTANT SAFETY INSTRUCTIONS before operating
this dryer.
Factors affecting drying time in any dryer include dampness of load prior
to drying, air flow and installation. Best performance is achieved when the
lint screen is clean and the exhaust duct requirements are met for type of
material, diameter, length, and number of elbows. Apartment complexes
and condominiums frequently use common exhaust systems; this usually
lengthens drying time and increases energy usage.
1. Check lint screen to make sure it is clean and in place.
2. Place wash load into dryer. Add a dryer fabric softener sheet if
desired.
3. Close dryer door. The dryer will not operate unless the door is closed.
4. Turn cycle selector clockwise to desired setting. (See "Dryer
Control Settings Chart.") The setting can be changed any time during
the cycle.
5. Push Start button for 2 seconds. The dryer will always stop when
the door is opened. To restart the dryer, close the door, then push the
Start button for 2 seconds. The dryer will not start if the cycle selector
is in the OFF position when the Start button is pushed.
6. Remove items immediately to help prevent wrinkling. If the load
is removed before time has elapsed, turn cycle selector to the OFF
position.
7. Clean lint screen after every load. Refer to the "Care and Cleaning"
section.
Adding or Removing Items
To add or remove items when the dryer is running, open the door. Allow
the dryer drum to coast to a complete stop before reaching inside.
To restart the dryer, close the door. Push the Start button for 2 seconds.
The dryer will stop if the button is released too soon. If the dryer does not
start, push the Start button again.
10