Publicité
Les langues disponibles
Les langues disponibles
Mounting bits and drills
Before any work on the machine (e.g. maintenance, tool
change, etc.) as well as during transport and storage,
set rotational direction switch to the centre position.
Unintentional actuation of the trigger can lead to injuries.
Rotate the front sleeve to adjust the chuck until the
opening is slightly larger than the shaft of the screwdriver/
drill bit that you wish to use. Insert the screwdriver/drill bit
into the chuck. Tighten the chuck against the screwdriver/
drill as described above (Keyless chuck).
Regulating the shaft speed
It is possible to regulate both shaft speeds from zero to
maximum by altering the pressure applied to the trigger.
This enables you to choose the optimum speed for the task
you are working on.
Reversing the direction of rotation
You can reverse the direction of rotation by using the
rotational direction switch (4).
To lock the trigger, set the selector to the mid position
between the right and left options.
Adjusting the tightening moment
Turn the torque regulator (2) to the desired position.
Settings 1-19 are used for tightening/loosening screws
(the higher the value, the greater the tightening moment).
Select the drill symbol before using the tool for drilling.
Magnetic bit holder
You can place the bits and drills you are currently using on
the magnetic bit holder (8) on top of your screwdriver/drill
to keep them close at hand while you are working.
20
Publicité
