Publicité
Les langues disponibles
Les langues disponibles
ASSEMBLY
Before any work on the machine (e.g. maintenance, tool
change, etc.) as well as during transport and storage,
set rotational direction switch to the centre position.
Unintentional actuation of the trigger can lead to injuries.
Charging the screwdriver/drill
First read the safety instructions and then follow the
charging instructions.
Connect USB-C cable end to USB-C port on the battery
pack (Pic. 2)(A). Connect the other USB cable end to a USB-
charger or USB-outlet that can provide sufficient power
to charge the screwdriver/drill. When the battery pack is
connected to the power supply, the diodes on the back of
the battery pack light up to indicate the charging status:
- Pulsating light - charging in progress
- Steady light for two minutes/no light - charging completed
Make sure that there are no knots or sharp bends in the
cable. After the battery pack is fully charged and the
battery pack remains connected to the power supply,
the diodes will stay lit for two minutes and then turn off.
When the charging is completed, disconnect the charging
cable and then slide the battery pack into the holder of
the screwdriver/drill. The screwdriver/drill is now ready to
use. When the screwdriver/drill is not in use, disconnect
the battery pack from the screwdriver/drill and store it
in a suitable place. Under normal conditions of use the
screwdriver can be recharged several hundred times.
17
Publicité
