Makita DFL651F Manuel D'instruction page 7

Lighting up the lamp(s)
CAUTION:
• Do not look in the light or see the source of light directly.
► 1 . Lamp
LED indicator / Beeper
► 1 . LED indicator
LED indicator / Beeper on the tool shows the following functions.
Function
Auto-stop fastening
Warning against insuffi-
cient fastening
Warning for battery
cartridge capacity
Checking the remain-
ing battery capacity,
Autostop
1
1
Status
This function works when Lights up in green for
the tool has reached the approximately one
preset fastening torque and second.
normal tightening has been
completed. This helps over-
tightening to be avoided.
Insufficient fastening has Lights up in red.
been performed when the
switch trigger has released
before reaching the preset
fastening torque.
This indicates the appro- Flickers in red slowly.
priate time to replace
the battery cartridge
when the battery power
becomes low.
This function works Lights up in red.
when the battery power
is almost used up. At
this time, tool stops
immediately.
Pull the switch trigger to light up the lamp. The lamp
keeps on lighting while the switch trigger is being pulled.
The lamp automatically goes out 10 seconds after the
switch trigger is released.
NOTE:
• Use a dry cloth to wipe the dirt off the lens of
lamp. Be careful not to scratch the lens of lamp,
or it may lower the illumination.
Status of the LED indicator/beeper
LED indicator
A long beep
A series of long beeps
A long beep
7 ENGLISH
Action to be taken
Beeper
–
Retighten the screw.
Replace the battery with
fully charged one.
Replace the battery with
fully charged one.
–