Storage; Cutter Plates - B.Braun Aesculap Econom CL Mode D'emploi

Aesculap
Battery-operated clipping machine Econom CL sheep shearing
Change the lower cutter plate
►
Loosen regulating nut 8, see Fig. A.
►
Loosen both clamping screws 9 and pull the lower cutting plate 1
away forward, see Fig. C.
►
Insert new cutter plate. Ensure that the lower cutter plate 1 protrudes
approx. 2 mm from the upper cutter plate 2, see Fig. D.
Adjusting the plate pressure
Note
The plate pressure must be set with the machine running and without aux-
iliary tools.
Note
If the plate pressure is too high, this results in the build-up of heat and
greater wear to the cutter plates.
►
Carefully unscrew the regulating nut 8 until the upper cutter plate 2
is no longer pressing against the lower cutter plate 1 (the sound of the
motor becomes noticeably higher-pitched), see Fig. A.
►
Tighten the regulating nut 8 until the motor begins to run somewhat
slower (take note of motor sound).
Cleaning the cutter head
►
The cutter head must be cleaned at least after each day of clipping
time or if it gets dirty.
►
Unlock and remove the Li-ion battery 38.
►
Remove both screws 6, see Fig. B.
►
Then turn the cutter head very slightly (about 15°) counterclockwise
and remove it from the motor shell.
►
Remove the cutter plates, see Changing the cutter plate.
►
Thoroughly clean the interior part and individual parts of the cutter
head using a brush.
►
Insert the cutter plate and tighten, see Changing the cutter plate.
►
Lubricate the gear wheel, see Lubricating the gear wheel.
►
Carefully place the cutter head on the motor. When re-attaching the
cutter head, ensure that it is turned 15° counterclockwise in such a
way that its lower flange engages with the groove of the motor hous-
ing.
►
Lubricate the cutter head, see Lubricating the shearing head.
Cleaning the air filter
►
Clean the air filter 37 at least once per day or if it gets dirty.
►
Remove the air filter 37 from the battery-operated clipping machine,
see Fig. G.
►
Thoroughly clean the air filter 37 in warm water with a brush.
►
Allow the air filter 37 to dry.
►
Clean the battery-operated clipping machine.
►
Place the air filter 37 on the battery-operated clipping machine.
8
Econom CL Schafschur
®
Re-sharpen the cutter plates
►
For sharpening the cutting plate, please contact Technical Service, see
Technical Service.
4.6

Storage

►
Clean the clipping machine and cutter plates thoroughly before stor-
ing, see Reprocessing.
►
Store the clipping machine in a dry, dark and clean room.
5.

Cutter plates

Cutter plates compatible with cutter head GT369
Art. no. Designation
GT578 Upper cutter plate with four cutting teeth
GT588 Lower cutter plate with 13 cutting teeth, 3.5 mm thick
GT594 Lower cutter plate with 13 cutting teeth, with outer
teeth curved outwards