Publicité
Les langues disponibles
Les langues disponibles
Contents
Symbols used in this manual .................. 26
Symbols on chainsaw ............................. 26
Important safety information ................... 27
Noise and vibration ................................. 31
Overview ................................................. 32
Technical specifications .......................... 33
Instructions for use.................................. 34
Work techniques ..................................... 40
Maintenance and care ............................ 42
Disposal information ............................... 47
conformity ........................................ 47
Symbols used in this
manual
WARNING!
Denotes impending danger. Non-observance
of this warning may result in death or ex-
tremely severe injuries.
CAUTION!
Denotes a potentially dangerous situation.
Non-observance of this warning may result in
injury or damage to property.
NOTE
Denotes tips for operation and important in-
formation.
Symbols on chainsaw
Opening for refilling "MIX GAS-
OLINE" 40:1
Location: Above fuel cap
Opening for refilling chain oil
Location: Above oil cap
Switch notices: Pressing the
switch to the "O" (STOP) posi-
tion switches off the engine.
Location: Left side rear handle
26
Original manual for petrol chainsaw FX-KSP series
Pulling the choke button as far as the arrow
allows the starting mode to be adjusted as fol-
lows:
Position 1 when engine is cold.
Position 0 when engine is hot.
Location: Left side rear handle
The directions indicate when
the chain brake is released
(white arrow) and activated
(black arrow).
Location: On front of chain cover
Cable starter with Easy Start
function. To start the machine,
preload the starter spring by
pulling slowly and evenly. It is
not necessary to yank it. Do
not pull beyond the dead cen-
tre point as the cable could oth-
erwise snap.
If the screw is turned with a
screwdriver in the direction of
arrow to the "MAX" position, oil
flow is stronger. Turning to the
"MIN" position results in oil flow
being weaker.
Location: On bottom rear
handle.
H = Speed increase screw, L =
Speed reduction screw, T =
Idle speed adjustment screw
Publicité
