Important Safety Instructions - Panasonic EY7440 Instructions D'utilisation

9) Do not touch the rotating parts to avoid
injury.
10) Do not use the tool continuously for a long
period of time. Stop using the tool from time
to time to avoid temperature rise and heat
overload of the motor.
11) Do not drop the tool.
Symbol
V
n
0
Revolutions or reciprocations per
.../min
Ah
Electrical capacity of battery pack
WARNING!
Some dust created by power sanding,
s a w i n g , g r i n d i n g , d r i l l i n g , a n d o t h e r
construction activities contains chemicals
known to the State of California to cause
cancer, birth defects or other reproductive
harm. Some examples of these chemicals
are:
• Lead from lead-based paints
• Crystalline silica from bricks and
cement and other masonry products
• Arsenic and chromium from chemi-
cally-treated lumber.
To reduce your exposure to these chemi-
cals: work in a well ventilated area, and
work with approved safety equipment,
such as dust masks that are specially
designed to filter out microscopic particles.
III
FOR BATTERY CHARGER
.
& BATTERY PACK

Important Safety Instructions

1) SAVE THESE INSTRUCTIONS -This
manual contains important safety
and operating instructions for battery
charger EY0L80.
) Before using battery charger, read all
instructions and cautionary markings
EY7440(UL).indb 5
Meaning
Volts
Direct current
No load speed
minutes
Rotation only
- 5 -
on battery charger, battery pack, and
product using battery pack.
3) CAUTION -To reduce the risk of injury,
charge only Panasonic Battery Pack as
shown in last page.
Other types of batteries may burst
causing personal injury and damage.
4) Do not expose charger and battery pack
to rain or snow.
5) To reduce risk of damaging the electric
plug and cord, pull by plug rather than
cord when disconnecting charger.
6) Make sure cord is located so that it
will not be stepped on, tripped over, or
otherwise subjected to damage or stress.
7) An extension cord should not be used
unless absolutely necessary.
Use of improper extension cord could
result in a risk of fire and electric shock.
If extension cord must be used, make
sure that:
a. pins on plug of extension cord are
the same number, size and shape as
those of plug on charger.
b. extension cord is properly wired and
in good electrical condition.
c. wire size is large enough for ampere
rating of charger as specified below.
RECOMMENDED MINIMUM AWG SIZE OF
EXTENSION CORDS FOR
BATTERY CHARGERS
AC Input Rating. Amperes
Equal to or But less
greater than than
0 
8) Do not operate charger with damaged
cord or plug-replace them immediately.
9) Do not operate charger if it has received
a s h a r p b l o w, b e e n d r o p p e d , o r
otherwise damaged in any way; take it
to a qualified service personnel.
10) Do not disassemble charger; take it
to a qualified service personnel when
service or repair is required. Incorrect
reassembly may result in a risk of
electric shock or fire.
11) To reduce the risk of electric shock,
unplug charger from outlet before
attempting any maintenance or cleaning.
1) The charger and battery pack are
specifically designed to work together.
Do not attempt to charge any other
AWG Size of Cord
Length of Cord,
Feet
5 50 100 150
18 18 18 16
2006/09/13 9:39:45