Vitrifrigo OCX2 Manuel D'instructions page 29

Problems Check that
it is energised
the "STAND-BY" switch A is active and the LED is on
the automatic circuit breaker of the electrical system is not disconnected
The appliance does not work
the plug is efficient and correctly inserted into the socket and the power outlet
works. For this verification, connect to the socket a device whose functioning is
certain
the supply cable is not interrupted
the ice maker is on a level surface
the ice maker is not in contact with furniture that can could cause vibrations
Noisy ice maker
the refrigerant circuit pipes located on the back have no contact points and
do not vibrate against the appliance
the door closes hermetically
the ice maker is not near heat sources
Ice maker with insufficient
the ice maker is sufficiently ventilated
production
the condenser is not clogged with dust
the fan turns freely
the refrigeration system is in operation and produces cold
there is water in the ice cube tray
the water system is efficient
there is sufficient water in the tank (Refill version)
The ice maker does not make
keys A and B are active
ice
the internal temperature in the cell is approximately ≤ -15°C
the ice level sensor is in the position
if there is water in the ice cube tray, check the functionality of the refrigerant
system
there is no cube stuck in the ice cube tray
The ice maker does not there is ice in the ice cube tray.
dispense ice If there is, reset the system by switching it off for ~4/5 hours.
ENG
29