Vitrifrigo OCX2 Manuel D'instructions page 26

"REFILL" Model start-up
Start the machine by keeping the start button A pressed for a few seconds. Open the
hatch and remove the tank, unscrew the cap on the top of the tank and pour drinking
water through the filler into the tank (min.2 litres/max.7 litres). In order to completely
disconnect the tank from the machine, disengage the water syphon tube by pressing
the release ring on the coupling and simultaneously pulling the tube upwards. Upon
insertion of the tank, the green light E will come on. If the red light C remains on, it means
that there is insufficient water.
ATTENTION
"HYDRO" Model start-up
Connect the flexible hose provided on the solenoid valve through the appropriate
threaded union, to the water supply.
The appliance is intended for operation with water pressure of between 1 and 3 bar.
Make sure that the water network supplies drinking water and that the pressure is such as
to obtain correct ice production for each discharge cycle (on 100g for 12 cubes, optimal
pressure 2 bar).
The use of a tap on the water line is recommended. Start the machine by keeping the
start button A pressed for a few seconds.
8. USING THE ICE MAKER
The ice maker has two operating modes:
• Ice production mode in which the ice maker produces crescents of ice
• FREEZER mode in which the ice maker does not produce crescents of ice but can be
used as a freezer.
Ice production mode
During the production of ice, the "production B" command must be active (LED on).
The production cycle proceeds as follows:
The base of the ice cube tray is filled with water through a water
ENG
26
• Fill the tank using only drinking water.
• In the versions with remote tank, do not place the tank above the
water level of the ice cube tray
supply or tank.
PRODUCTION