Vitrifrigo OCX2 Manuel D'instructions page 25

Fixing the appliance
To secure the appliance in the built-in space, use only the holes in the relevant fastening
profile (Annex 3).
6. ELECTRICAL CONNECTION
ATTENTION The operator must be able to disconnect the appliance from the mains
electricity.
Therefore, make sure that there is an access point to the power supply network near
the appliance and/or that the system is equipped with an omnipolar differential
magnetothermic switch, 6A type AC sensitivity 30 mA, with minimum 3mm contact
opening.
Before connecting the product, make sure that the voltage corresponds to that shown
on the identification label or that shown on the label on the compressor.
ATTENTION by law, the appliance must be earthed. Make sure that the earthing
system for the electrical network is working perfectly.
We accept no responsibility whatsoever for any injury to people or damage to property
deriving from the failure to properly comply with this regulation.
The use of adaptors, multiple sockets and extension cords is not recommended.
In the event that the appliance's plug and the socket are not compatible, replace the
plug with a suitable one. This operation must be done by a suitably qualified person who
must ensure that the cable section of the plug is appropriate to the power absorbed by
the appliance. Do not interconnect any other type of appliance to the ice maker.
7. START-UP
Upon installation, the Ice Maker performs an initial vacuum cycle and subsequent cycles
with ice production. The first cubes are dispensed after approximately 1 hour.
Control panel
A
A
Start
B
Production
C
Indicator light 1
B C
D
Indicator light 2
E
Indicator light 3
D E
ENG
25