Publicité
STEP 1
Center the wire frame on the
door, and mark and pre-drill the
hole locations. The door mount
bar may be required for proper
installation on a panel door.
(See Figure 1).
Note: Be careful not to drill
through your door and ensure
not to mount too high on the
door as it will hit the face
frame.
5
#2
64
STEP 2
Use the provided (4) #6
Phillips head screw caps and
6X 5/8" Phillips flat head
wood screws to secure the
wire frame to the cabinet door
(See Figures 2A, 2B, and 2C).
Note: Use (4) M4 X 8MM
flat head Phillips screws
should you need to install
the frame on the door
mount bar then to the door
with (2) #6 x 5/8" flat head
Phillips SM screws.
STEP 3
Insert waste container with
lid into the wire holder and
product is ready for use (See
Figure 3).
2
FIG. 1
For door mount bar
x
Mark screw
locations
FIG. 2A
FIG. 2B
FIG. 3
Customer Service: 800-626-1126 | rev-a-shelf.com
Face Frame
x
13"
(330mm)
Frameless
8-1/2"
(216mm)
x
x
x
x
1-3/4"
(44mm)
Mark screw
locations
FIG. 2C
Publicité
