Klarstein CLARA 10040140 Mode D'emploi page 30

EN
30
Installation with external ventilation
WARNING
Risk of electrical shock! For safety reasons, only use fastening or
assembly screws of the size recommended in these operating
instructions. If you do not install the screws or the fastening device
according to these instructions, it can lead to electrical hazards.
1
After you have determined the height
of the cooker hood, mark the position
of the holes for the suspension of the
cooker hood and the bracket for the
inner chimney element. Drill 4 holes
(Ø8): 2 holes for the support of the
inner chimney element and 2 holes
for the suspension of the extractor
hood. Make sure that the cooker hood
hangs straight. The attachment point
for holding the inner chimney element
marks the highest point of the inner
chimney element.
Bracket for the inner chimney element
2
Insert dowels into the holes in the
wall and screw 2 screws (4 x 30 mm)
into the dowels to fi x the cooker hood.
Then use 2 screws (4 x 40 mm) to fi x
the bracket for the inner chimney
element.