Transistor AutoMini Digital Mode D'emploi page 20

ENGLISH
3. Connecting the listening loop
Select how you wish to listen to the sound. Wearers of hearing instruments can listen via
the chair loop supplied or via our neck loop which can be purchased as an accessory.
Listening option A: Chair loop
1. Turn the volume down to minimum (0) so that the sound level is not too
high at the outset. The DELAY knob should be in OFF mode.
2. Insert the chair loop connector in the amplifier's LOOP socket. The
green LOOP OK lamp comes on.
3. Place the chair loop on the seat, either below or above the seat cushion.
4. Lay the cord supplied along the wall. Make sure that the cord is posi-
tioned so that you cannot trip up on it.
5. Set the hearing instrument to the T or MT position.
6. Adjust the volume control to a comfortable level and sit on the chair
loop when listening.
Listening option B: Neck loop (accessory)
Our neck loop with volume control is an alternative to the chair loop. Sold
separately. Fitted as set out in step 1 and 2 above and worn round the neck. Set
the hearing instrument to the T or MT position.
Synchronization of sound - the DELAY knob
Unsynchronized sound can be found in certain LED, LCD or PLASMA TV sets. If
the sound is not synchronized with the image (the sound precedes the image)
you can adjust this with the knob marked "DELAY" on the backside of AutoMini.
Increase the delay of the sound by turning the DELAY knob clockwise until you
find that the sound is synchronized with the image. This should only be needed
to do once.
20