Transistor AutoMini Digital Mode D'emploi page 16

ENGLISH
Connection option B: RCA Line out or 3.5 mm audio output jack
Check whether your TV has a Line Out output (usually on the rear of
L
the TV, see TV user manual). Use the RCA Line out connector cable
to connect the AutoMini:
R
-->
If your TV does not have a Line Out output, move on to connection option C.
Please note! Some TVs have a sound input on the front or on the side
which looks like a Line Out output but which is NOT able to transmit
sound to an amplifier. This is usually marked "Audio" and is located next
to sockets marked "Video" and "S-Video" (se TV user manual).
L
R
Line Output
1. Connect the Line Out cord between the TV and the amplifier's
LINE/DIGITAL socket. The DELAY knob should be in OFF mode.
2. Set the switch on the front of the amplifier to the LINE/DIGI position.
The relevant lamp will come on.
Proceed to step 3: "Connecting the listening loop", page 17.
-->
If your TV does not have a Line Out output connector check if it has a 3.5 mm
audio output jack (can be located both on the front and the rear of the TV). If
so, use the 3.5 mm audio cable to connect the AutoMini:
16