Transistor AutoMini Digital Mode D'emploi page 18

ENGLISH
Connection option C: SCART connector (Extra accessory)
Check whether your TV has a SCART socket. It does not matter whether it
is in use.
--> If it does not have one, proceed to connection option D.
SCART socket
1. Connect the amplifier to the TV SCART socket using the SCART cord
supplied. If the TV has more than one SCART socket, use the one that
the TV manual recommends for video (usually SCART 1 or AV1).
If the TV's SCART socket is being used by one or more external units (e.g.
video, DVD, digibox, satellite receiver), connect the amplifier between the TV
and the external units. The units which are connected to the TV should be
connected in series (see illustration above). The DELAY knob on the backside
of AutoMini should be in OFF mode.
2. Set the switch on the front of the amplifier to the TV EXT position. One
of the lamps, TV or EXT, will come on, depending on whether the TV
or an external unit is being used at present.
--> Proceed to step 3: "Connecting the listening loop", page 15.
Please note! When correctly connected, the TV picture and sound will automati-
cally be changed to the programme source you selected (e.g. video, DVD, digibox,
satellite receiver). If you are watching video, DVD, satellite TV or another external
unit and then switch to a standard analogue TV channel, in some cases you may,
however, receive the wrong sound on the TV. In that case switch off the external
unit, or all the external units, to obtain the correct sound. This phenomenon will
never occur if you use connection options A, B or D.
18
TV EXT MIC/LINE
Video
Digibox
DVD