Danfoss TP7000-RF Instructions D'installation page 9

The unit is now in RUN mode (colon
fl ashes in display) and the heating
will operate according to the preset
programmes.
Before you change the preset programmes
Your installer will have set your unit to operate in either 7-day
mode or 5/2 day mode. To tell which mode your unit is set
press PROG until Event 1 fl ashes in the display.
1
1 2 3 4 5
Programming in 7-day mode
(separate programmes for each day of the week)
a) Press PROG until Event 1
fl ashes, then press DAY to move from
current day to Day 1.
b) Amend the time and temperature
as follows:
i) Use + and – buttons to
alter time (press and hold to
change in 10 min increments).
Use L and M buttons to alter
ii)
temperature in 0.5°C (1°F) steps.
iii) Press NEXT to advance to
next Event
iv) Repeat steps i,ii & iii above for
Events 2, 3, 4, 5 & 6
This unit is in 7-day mode and you can
programme different settings for each day of the
week (see page 9-10).
This unit is in 5/2 day mode and you can enter
one of set of programmes for weekdays and
another set for weekends (see page 10).
1
9