Télécharger Imprimer la page

Bosch GBH18V-20 Consignes De Fonctionnement/Sécurité page 14

Masquer les pouces Voir aussi pour GBH18V-20:

Publicité

Les langues disponibles

Les langues disponibles

2610048709.qxp_GBH18V-20 6/19/17 12:41 PM Page 14
For drilling operations only:
The HDC200, HDC250 Bosch dust extraction
attachments are designed to be used in
drilling applications in concrete and masonry
type materials.
Drilling Capacity
HDC 200
1/4" — 1-3/8"
2-5/8"
maximum
* brush ring 2 must be
removed for diameters
larger than 1-3/8"
The HDC200 is optimized for use with drill bit
diameters from 1/4" to 1-3/8". The maximum
bit diameter is 2-5/8". When using with brush
ring 2 maximum bit diameter is no larger than
1-3/8".
The HDC250 is designed for use with large
diameter bits including diamond and carbide
tipped core bits. It is optimized for bit
diameters from 2-1/4" to 5". The maximum bit
diameter is 6". When using with brush ring 2
maximum bit diameter is no larger than 5".
Insert the vacuum hose 6 from the dust
extractor into the dust port 3 of the dust
extraction unit (Fig. A).
The Bosch dust extractor provides two
methods for connecting the hose to the dust
extraction attachment: sleeve nozzle 5 and
snap-in connector 4. To use the sleeve
FIG.
2
3
All manuals and user guides at all-guides.com
Dust Extraction
HDC250
2-1/4" — 5"
*
6"
**
maximum
** brush ring 2 must be
removed for diameters
larger than 5"
1
4
6
nozzle slide the nozzle into the dust port of
the attachment. To use the snap-in
connector for more secure connection,
remove the rubber nozzle 5 from the vacuum
hose 6. Press the snap-in connector into the
dust port 3 until you hear the click (Fig. A).
Dust port adaptors are also available to
connect the Bosch dust extraction
attachment to any common size vacuum
hose. See Boschtools.com for details.
Turn the dust extractor on and place the
attachment 1 on the wall (or the floor), over the
desired drilling location so that the center of the
hole lines up with the center of the opening of
the brush ring 2. Note: the suction from the dust
extractor will hold the attachment in place on
the work surface. Place the drill bit through the
opening in the brush ring in the desired drilling
location and drill the desired hole (Fig. B). In
certain situations, where precise hold drilling is
required, first place the drill bit through the
opening in the brush ring 2, in the attachment
1, and position the tip of the drill bit in the
desired drilling location. Follow all tool safety
and operating instructions.
Note: for best results, continue running the
tool even when removing the bit from the
hole. The combination of the vacuum with
the spinning motion of the bit helps remove a
majority of the dust from the hole.
See Bosch HDC200, HDC250 instruction
manual for more details.
FIG. B
5
-14-

Publicité

loading