Whirlpool WNF 711 E W Guide Rapide

Quick guide
THANK YOU FOR BUYING A WHIRLPOOL PRODUCT
In order to receive a more complete assistance, please
register your product on
FIRST TIME USE
After installation, wait at least two hours before connecting the
appliance to the power supply. Once connected, it will start working
automatically. The ideal temperature settings are preset from the
factory.
CONTROL PANEL
ON/STAND BY
To put the product in Stand-by, press and hold the On/Stand-By button
for more than 3 seconds.
Press again to reactivate the appliance.
TEMPERATURE SETTING
Press the Temperature button on the control panel to adjust the
temperature from the warmest through the lower to the coldest
level. Pressing the Temperature button, the temperature setting will
change cyclically. At first plug-in of appliance temperature setpoint is
present at medium position (factory setting). Following table shows
temperature setpoints:
High temp.
Med-high temp.
Medium temp.
Med-low temp.
Low temp.
Fast Cooling
OFF ON
Recommended setting:
• Refrigerator compartment: +4°C or MED
• Freezer compartment: -18°C or -20°C
Note: Displayed set points correspond to the average temperature
throughout the whole refrigerator.
* Available only on certain models
www . whirlpool . eu/ register
Before using the appliance carefully read the Safety
Instruction.
After turning the appliance on, wait 4-6 hours for it to reach the correct
food storage temperature.
1.
Indicator Leds (to display the current temperature set point or the
Fast Cooling function)
2. On/Stand-By Button / Temperature Button
FAST COOLING
The use of this function is recommended when placing a very high
quantity of food to be frozen in the freezer compartment.
24 hours before freezing fresh food, press and hold for 3 seconds the
Fast Cooling button / Temperature button on the control panel till all
the 3 LEDs will turn on, to activate the Fast Cooling function.
After 24 hours place the food to be frozen in the freezing zone drawer
of freezer compartment.
The function is automatically deactivated after 48 hours and return to
previous selected set point.
The function can be manually deactivated by pressing and holding for
3 seconds the Temperature button on the control panel.
LED LIGHT
This product contains a light source of energy efficiency class G.
If the LED light system does not work, please contact the Service to
replace it.
Important: The refrigerator compartment light switches on when
the refrigerator door is opened. If the door is kept open for more than
8 minutes the light will be automatically switched off.
6 SENSE
TH
This function automatically works to ensure the optimal conditions
to preserve the stored food. The "6
activated when:
• a large amount of food is loaded into the refrigerator
• the refrigerator door is left open for a long time
• a prolonged power failure takes place, causing the internal
temperature of the appliance to increase to values that cannot
guarantee safe storage of food.
Sense" function is automatically
th
EN