Publicité
Les langues disponibles
Les langues disponibles
Steam ironing
1.
Put the unit base on a stable and level surface.
2.
Grasp the water tank handle and then pull out the water tank
horizontally, fill the water tank with water through the filling aperture
and then replace the water tank well in position (see Fig.4). Make sure
the water tank shall be pulled out horizontally when removing the
water tank. You had better use purified water with less calcium
particles. The maximum capacity of water tank is 1.2L, the water level
shall not be exceeded the maximum level.
3.
Put the iron on the thermal insulation stand of unit base correctly (see
Fig.3).
4.
Connect the plug to wall outlet, and then turn the temperature dial to
select your desired temperature setting, which is depended on the
fabric of garment. Refer to "IRONING TIPS" and "ADDITIONAL
TABLE" as below when select temperature.
5.
And then the temperature indicator illuminates and the iron starts
heating.
6.
After a few minutes, the temperature indicator extinguishes, which
indicates the soleplate temperature has achieved the selected
temperature. And you can start ironing with steam now.
7.
Press the steam trigger with a little force, the steam will be sprayed
from the soleplate continuously, and then you can iron the garment
with steam.
NOTE: There may be dripping water during spraying steam when the
temperature is lower than that of the second setting. This is normal.
8.
If you want to activate the "Shot of steam" function to remove tough
wrinkle, continuously press the steam trigger twice to produce shot of
steam.
CAUTIONS:
(1) Do not touch hot soleplate at any time before cooling down!
(2) Never direct the steam at people!
(3) Do not activate the steam function when the iron is placed on the
unit base to avoid being scalded by steam.
Publicité
