AYA CV 015 SD Manuel D'utilisation page 26

BEFORE FIRST USE
1. Remove any sticker or protective foil from the soleplate.
Fill the water tank with water and heat up the iron at the maximum
2. temperature, and then iron over a piece of damp cloth for several
minutes for the purpose of removing any residue on the soleplate
according to the section of "Steam ironing".
NOTE：
(1) It is normal that strange odor comes out from the unit for the first
use. This will cease after a short while.
(2) Some particles may come out of the soleplate when you use the
iron for the first time. This is normal, the particles are harmless and
stop coming out of the iron after a short while.
USING YOUR STEAM STATION
The appliance has two ironing ways. You can use dry ironing or steam
ironing, the details refer to the following.
Dry ironing
1. Put the unit base on a stable and level surface.
2. Put the iron on the thermal insulation stand of unit base correctly (see
Fig.3).
Connect the plug to wall outlet, and then turn the temperature dial to
3.
select your desired temperature setting, which is depended on the
fabric of garment. Refer to "IRONING TIPS" and "ADDITIONAL
TABLE" as below when select temperature.
And then the temperature indicator illuminates and the iron starts
4.
heating.
5. When the temperature of soleplate reaches the selected temperature,
the temperature indicator turns off, and you can start ironing now.
WARNING: Never touch hot soleplate at any time before cooling
down!