AYA CV 015 SD Manuel D'utilisation page 24

3. When the clean indicator is extinguished, if the user needs to perform
cleaning, hold and press the "Clean button" for 2 seconds.When the
buzzer sounds, the operator should keep away from the appliance to
avoid being burnt by high-temperature steam during the cleaning
process. And the appliance enters into the cleaning mode and the
clean indicator blinks. After about 3 minutes, the cleaning is completed
and the appliance returns to the working condition.
NOTES
(1) For better cleaning, please ensure that the temperature dial be
turned to "MAX" setting before activate the "Clean" function. The
cleaning may be not so good or can not be performed if the
temperature dial is turned to other temperature settings except "MAX"
setting.
(2) Before activate the "Clean" function, please ensure that the
appliance shall be at the "Steam" mode. And please press the "Steam
trigger" once to make the water spray button return to its original
position if the appliance is not at the "Steam" mode. The appliance will
spray water during cleaning if the appliance is performed cleaning
under the "Water Spray" mode. The appliance must be performed
cleaning under the "Steam" mode.
Shot of steam
Shot of steam can be activated after pressing the steam trigger twice
continuously.
Vertical steam
With vertical steam function for removing wrinkles from hanging
garments, curtains, drapes, and more.
Cord winding groove
When not in use, the steam supply hose can be wound along the cord
winding groove for storage and the power cord can be tied well with a
cable tie. Follow the operation in the section of "CLEANING AND
MAINTENANCE".
Cord clip
When not in use, the power cord can be tied with a cable tie and the
steam supply hose can be stored at the cord clips (see Fig.1 & Fig.2).