Franke FDF 9274 I XS Mode D'emploi Et Installation page 9

• Loosen the two screws fastening the lower chimney and
remove this from the lower frame.
• Loosen the two screws fastening the upper chimney and
remove this from the upper frame.
If you wish to adjust the height of the frame, proceed as fol-
lows:
• Unfasten the metric screws joining the two columns, lo-
cated at the sides of the frame.
• Adjust the frame to the height required, then refit all the
screws removed as above.
• Insert the upper chimney stack from above, and leave it
running free on the frame.
• Lift up the frame, fit the frame slots onto the screws up
to the slot end positions.
• Tighten the two screws and fasten the other two screws
provided with the hood.
Before tightening the screws completely it is possible to
adjust the frame by turning it. Make sure that the screws do
not come out of their seats in the slotted holes.
• The frame mountings must be secure to withstand the
weight of the hood and any stresses caused by the occa-
sional side thrust applied to the device.
On completion, check that the base is stable, even if the
frame is subjected to bending.
• In all cases where the ceiling is not strong enough at the
suspension point, the installer must provide strengthening
using suitable plates and backing pieces anchored to the
structurally sound parts.
EN
Fixing the frame
1
1
2
2
9
9