Franke FDF 9274 I XS Mode D'emploi Et Installation page 11

Flue assembly - Mounting the hood body
• Position the upper chimney section and fix the
upper part to the frame using the 2 screws 12c
(2,9 x 6,5) provided.
• Similarly, position the lower chimney section
and fix the lower part to the frame using the 2
screws 12c (2,9 x 6,5) provided.
Before fixing the hood canopy to the frame:
• Screw the 2 screws 12f half way into the holes
provided in the sides of the bottom of the
frame.
• Remove the grease filters from the hood can-
opy.
• Remove any activated charcoal filters.
• Lift the hood canopy and engage the screws 12f
in the slots (A) as far as they will go.
• Working from below, fix the hood canopy to
the frame (B), using the 4 screws 12q and 4
washers 22 provided, then tighten all the screws
securely.
ELECTRICAL CONNECTION
• Connect the Hood to the Mains Power Supply,
inserting a bipolar switch with a contact
aperture of at least 3 mm.
• Remove the Grease filters (see paragraph
"Maintenance") and make sure that the Power
cable (A) has been properly inserted into the
Suction fan socket.
• Fasten the connector B to the free socket at the
side of the suction fan
EN
A
B
1
11