Franke FDF 9274 I XS Mode D'emploi Et Installation page 10

Connections
DUCTED VERSION AIR EXHAUST SYSTEM
When installing the ducted version, connect the
hood to the chimney using either a flexible or
rigid pipe ø 150 or 120 mm, the choice of which
is left to the installer.
• To install a ø 120 mm air exhaust connection,
insert the reducer flange 9 on the hood body
outlet.
• Fix the pipe in position using sufficient pipe
clamps (not supplied).
• Remove any activated charcoal filters.
Air outlet – Recirculation Version
• Insert the Connector extensions 14.1 into the
side of the Connector 15.
• Insert the Connector 15 into the Support
bracket 7.3 and fix it with the screws.
• Fasten the Support bracket 7.3, fixing it to the
upper part with the Screws.
• Make sure that the Connector extensions out-
let 14.1 is in correspondence with the Chim-
ney openings both horizontally and vertically.
• Join the Connector 15 to the Hood canopy
outlet using a rigid or flexible pipe ø¸150 mm,
selection of which is at the discretion of the
installation technician.
• Make sure that the Activated charcoal odour
filter has been fitted.
EN
ø 150
25
12c
7.3
14.1
15
7.3
12e
ø 120
25
9
1
10