tau K130MA Notice D'installation page 21

J3 (SM)
MEMORY CARD
J4
AUX
J5 ENCODER
ENERGY SAVING
J6
MODE
IMPORTANT:
do not power up auxiliary relays o other devices through the 18-24V DC output (terminals 11 – 12)
•
to avoid malfunctions of the control unit. Use separated power supply / transformers instead;
• do not connect switching feeders or similar apparatus close to the automation that may be a
source of disturbance.
5. LOGIC ADJUSTMENTS
Make the logic adjustments.
Note: when any adjusting devices (trimmers or dip-switches) on the control panel are operated,
a complete manoeuvre must be carried out in order for the new settings to take effect.
TRIMMER
V-RAL
adjusts the automation deceleration speed during the final section of the stroke;
Note: When memorizing the stroke, set the TRIMMER RALL fully turned coun-
terclockwise (minimum deceleration speed).
FR. obstacle detection sensitivity adjustment.
Note: by rotating the TRIMMER FR. clockwise the sensitivity of the gearmotor
to obstacles diminishes and therefore the thrust force increases; vice-versa, by
rotating it counter-clockwise, the sensitivity of the gearmotor to obstacles
increases and therefore the thrust force diminishes.
Beyond a certain threshold, the TRIMMER FR inhibits the detection of obstacles.
This is signaled during the maneuvers by 7 orange flashes of the DL2
T.C.A.
Automatic Closing time adjustment: from about 1 to 120 seconds (see dip-switch no. 1);
Dip switch
AUTOMATIC
1
CLOSING
2 2 / 4 STROKE
CLOSES
3 AFTER THE
PHOTOCELL
4 NO REVERSE
PRE-
5
FLASHING
Quick plug-in for MEMORY CARD connection for transmitters codes.
Quick coupling for the connection of the T-WIFI, T-CONNECT and T-COMM
devices
Quick plug-in for ENCODER. Blue= 0 Vcc (- GND),
brown= 5 Vcc (+5V), white= ENCODER SIGNAL (ENC);
Quick plug-in for ENERGY SAVING MODE activazione. Once activated, at
the end of each manouvre, outputs 11-12, 12-13, 14-15, 16-17 and 16-18
will be switched off.
when completely open, closure is automatic after the set time on the T.C.A.
On
trimmer has past.
Off the closing manoeuvre requires a manual command.
when the automation is operating, a sequence of opening/closing commands
On
causes the automation to OPEN-CLOSE-OPEN-CLOSE, etc.
in the same conditions, the same sequence of commands causes the auto-
Off
mation to OPEN-STOP-CLOSE-STOP-OPEN-STOP, etc . (step-by step function)
(see also dip switch 4).
after the photocell is activated (input 7 - 9), the automation closes automat-
On
ically after 5 seconds.
Off function off.
the automation ignores the closing commands during opening and will close
On
according to the automatic closing time
Off the automation responds as established by dip switch No. 2.
On the pre-flashing function is enabled.
Off the pre-flashing function is disabled.
21
V-RAL