Publicité
Les langues disponibles
Les langues disponibles
E
E
Read and follow all instructions and Safety Precautions before using this
The GTi Pressure Feed Spraygun Kit is approved to ATEX regulations 94/9/EC, protection
level;
II 2 G X, Suitable for use in Zones 1 and 2
Important: These Sprayguns are suitable for use with both waterbased and solvent based
coating materials. The design uses EPA compliant atomising (Devilbiss Trans-Tech®)
technology to reduce overspray and improve coating efficiency. Nozzles and Needles are
manufactured in Stainless Steel. These guns are not designed for use with highly corrosive
and/or abrasive materials and if used with such materials it must be expected that the need for
cleaning and/or replacement of parts will be increased. If there is any doubt regarding the
suitability of a specific material contact your local Distributor or ITW Finishing direct.
Example:
Aircap Number
Gunbody colour
B = blue
EC Declaration of Conformity
We: ITW Finishing UK, Ringwood Rd, Bournemouth, Dorset, BH11 9LH, UK, as the
manufacturer of the Spraygun model GTi-P, declare, under our sole responsibility, that the
equipment to which this document relates is in conformity with the following standards or other
normative documents:
BS EN 292-1 PARTS 1 & 2: 1991, BS EN 1953: 1999; and thereby conform to the
protection requirements of Council Directive 89/392/EEC relating to Machinery Safety
Directive, and;
EN 13463-1:2001, council Directive 94/9/EC relating to Equipment and Protective
Systems intended for use in Potentially Explosive Atmospheres protection level II 2 G.
This product also complies with the requirements of the EPA guidelines, PG6/34.
Transfer efficiency certificates are available on request.
ITW Finishing Systems and Products reserve the right to modify equipment specification without prior notice.
© 2003 ITW Finishing Systems and Products
All manuals and user guides at all-guides.com
Operation Manual
GTi – Pressure Feed Spraygun
Important
equipment
Description
Model Part Number
GTI-P110B-14
Nozzle size
B. Holt, General Manager
30th June 2003
2
Publicité
