Cardin Elettronica DKS1000R Mode D'emploi page 22

10. DKS1000R interface setup
Relay output mode (with this procedure you can set the activation mode for each relay individually).
- Switch off the power to the interface.
- Set the dips according to the table.
- Press and hold down the button P2.
- Power up the interface.;
- The interface will sound two long beeps.
The parameters have been set.
Relay activation mode:
It is possible to set the relay activation mode to ON/OFF, Manual or Timer Controlled.
1. ON/OFF activation.
The jumpers J1, J2, J3 and J4 are used to set the corresponding relays: CHA, CHB, CHC, CHD.
Move the jumpers to position 1 to set the corresponding output mode to ON/OFF.
2. Manual or Timer controlled activation.
The jumpers J1, J2, J3 and J4 are used to set the corresponding relays: CHA, CHB, CHC, CHD.
Move the jumpers to position 1 to set the corresponding output mode to Manual or timer-controlled activation.
- Switch off the power to the interface.
- Set the dips according to the table.
- Press and hold down the button P1.
- Power up the interface.;
- The interface will sound one long beep.
The parameters have been set.
22
Relay output mode
OFF
Dip #1 NO Output relay 1 NC Output relay 1
Dip #2 NO Output relay 2 NC Output relay 2
Dip #3 NO Output relay 3 NC Output relay 3
Dip #4 NO Output relay 4 NC Output relay 4
Pos.1 Pos.2
Manual / Timer-controlled activation
OFF
Dip #1 Relay 1 manual Relay 1 timer controlled
Dip #2 Relay 2 manual Relay 2 timer controlled
Dip #3 Relay 3 manual Relay 3 timer controlled
Dip #4 Relay 4 manual Relay 4 timer controlled
ON
J1
J2
J3
J4
ON