Philips FC8140 Mode D'emploi page 10

English
10
1 To open the HEPA exhaust filter grille, grab the tabs and pull the grille upwards to remove it
from the appliance (Fig. 33).
2 Remove the HEPA exhaust filter.
3 Rinse the pleated side of the HEPA exhaust filter under a hot slow-running tap as described
in steps 11 and 13 of section 'Emptying the dust container' above.
4 Place the dry HEPA exhaust filter back into the appliance.
5 To close the HEPA exhaust filter grille, first align the lugs on the top of the grille with the
slots in the appliance (1). Then press the tabs downwards until the grille locks into place
(2) ('click') (Fig. 34).
Cleaning the motor protection filter (specific types only)
To maintain optimal performance, clean the motor protection filter at least once a year.
1 Lift the dust container out of the appliance by its handle.
2 Pull the filter holder with the motor protection filter out of the appliance. (Fig. 35)
3 Take the motor protection filter out of the holder. Shake the motor protection filter over a
dustbin to clean it.
4 Put the filter in the filter holder and slide the filter holder back into the appliance.
5 Put the dust container back into the appliance.
Cleaning the mini turbo brush
To clean the brush inside the mini turbo brush, follow the steps below.
1 Rotate the brush inside the mini turbo brush until the cutting groove faces you. Use a pair of
scissors to cut the hairs, threads etc. that have collected around the brush. (Fig. 36)
2 Remove fluff, hairs and other dirt from the brush.
replacement
The plug must be removed from the socket-outlet before cleaning or maintaining the appliance.
Replacing filters
Replace the HEPA dust container filter and the HEPA exhaust filter every 12 months.
HEPA filters
- To remove the old filter and place the new filter, follow the instructions for removing and
placing the filters in chapter 'Cleaning and maintenance'.
ordering accessories
To purchase accessories for this appliance, please visit our online shop at www.shop.philips.com/
service. If the online shop is not available in your country, go to your Philips dealer or a Philips
service centre. If you have any difficulties obtaining accessories for your appliance, please contact the
Philips Consumer Care Centre in your country. You find its contact details in the worldwide
guarantee leaflet.
Ordering filters and accessories
- HEPA exhaust filters are available under type number FC8070.
- Dust container filters (HEPA and foam) are available under type number FC8071.