Phase Linear UMP9020 Manuel De L'utilisateur page 4

All manuals and user guides at all-guides.com
WIRING
CD Changer
Connector
Antenna
Connector
Subwoofer Output
Connect to optional
subwoofer.
Amplifier Wiring
Connect line out for
optional external
amplifiers. The red
connector is for the right
and the white connector is
for the left.
CAUTION: Failure to wire exactly as shown
may cause electrical damage to the radio.
WARNING! Never combine (bridge) outputs for
use with 1 speaker.
WARNING! Never ground negative speaker
leads to chassis ground.
15 15
Blue
Gray
Rear
Brown
Front
LF/AVG
White/Black (-) Gray/Black (-)
White (+)
LR/ARG
Green/Black (-) Violet/Black (-)
Green (+) Violet (+)
4
Power Antenna
Connect to power antenna
or amplifier. If not used, tape
Blue
bare end of wire.
Black Ground
Connect to ground terminal.
Memory/Battery
Yellow
+
Connect to battery or 12 volt
power source that is always
live. The radio will not work
if this wire is not connected.
Red
Accessory/Ignition
0.5A
Connect to existing radio
wire or radio fuse.
RF/AVD
Fuses
When replacing a fuse,
make sure the new fuse is
Gray (+)
the correct type and
RR/ARD
amperage (15 amp ATO).
Using an incorrect fuse
could damage the radio.
UMP9020
Auxiliary Input