Phase Linear UMP9020 Manuel De L'utilisateur page 3

All manuals and user guides at all-guides.com
UMP9020
INSTALLATION INSTRUCTIONS
ISO Installation
This unit is designed to fit into a 2.0 DIN
dashboard opening, found in many imported
cars. The unit has threaded holes in the chassis
side panels which may be used with the original
factory mounting brackets of some Toyota,
Nissan, Mitsubishi, Isuzu, Hyundai and Honda
vehicles to mount the radio to the dashboard.
Please consult with your local car stereo
specialty shop for assistance on this type of
installation.
1. Remove the existing factory radio from the
dashboard or center console mounting.
Save all hardware and brackets as they
will be used to mount the new radio.
2. Carefully unsnap the plastic frame from
the front of the new radio chassis. Remove
and discard the frame.
3. Remove the factory mounting brackets
and hardware from the existing radio and
attach them to the new radio.
CAUTION: Do not exceed M5 X 6 MM screw
size. Longer screws may touch and damage
components inside the chassis.
4. Place the radio in front of the dashboard
opening so the wiring can be brought
through the mounting sleeve. Follow the
wiring diagram carefully and make certain
ISO INSTALLATION
all connections are secure and insulated
with wire nuts or electrical tape. After
completing the wiring connections, plug
the 14-pin connector into the mating
socket on the rear of the chassis, attach
the front panel, and turn the unit on to
confirm operation (vehicle ignition switch
must be "on"). If the unit does not operate,
re-check all wiring until the problem is
corrected.
5. Mount the new radio assembly to the
dashboard or center console using the
reverse procedure in step 1.
3
CAUTION: The support strap must be used
to prevent damage to the dashboard from
the weight of the radio or improper
operation due to vibration.
CAUTION: For proper operation of the CD
player, the chassis must be mounted within
20° of horizontal. Make sure the unit is
mounted within this limitation.