HumanTechnik Signolux DS-2 Mode D'emploi page 12

Alarm ON / OFF
The waking alarm can be switched on
and off with the slider switch on the
left side of the alarm clock.
Slider in upper position (green area is
visible): Alarm is switched ON.
Slider in lower position: Alarm is swit-
ched OFF.
Alarm tone ON / OFF
Press the alarm tone button » « for
one second to switch the alarm tone
ON or OFF. If the alarm tone is on, the
speaker symbol will be visible in the
display.
Setting the alarm tone volume
Press and hold the alarm tone button
» « while adjusting the volume of
the alarm tone. After 2 seconds, the
alarm tone can be heard. Keep the
alarm tone button pressed and turn
the adjusting wheel to the left or right
to adjust the desired alarm tone vo-
lume. Release the alarm tone button
to end the volume setting procedure.
Setting the alarm tone pitch
While adjusting the alarm tone pitch,
press and hold both the alarm tone
button » « and the spherical snooze
button at the same time. After 2 se-
conds, the alarm tone can be heard.
Keep the alarm tone button and the
snooze button pressed and turn the
adjusting wheel to the left or right to
English 12
adjust the desired alarm tone pitch.
Release the buttons to end the pitch
setting procedure.
Flash ON / OFF
Press and hold the flash button »
for one second to switch the flash
ON or OFF. If the flash is on, the flash
symbol will be visible in the display.
Setting the
brightness
The brightness of the displayed
digits is automatically adjusted ac-
cording to the light conditions within
the room. During the day, the digits
are displayed with full brightness. In
darkness, the set nighttime display
brightness is activated.
To set the nighttime display bright-
ness, press and hold the flash button
» «. Keep the flash button pressed
and turn the adjusting wheel to the left
or right to adjust the desired display
brightness for the night. Release the
button to end the setting procedure.
If this adjustment is done during day-
light conditions, the display will switch
back to full brightness after a few se-
conds.
Snooze function
You can interupt a current alarm by
pressing on the spherical snooze but-
ton. The alarm will be repeated after
5 minutes.
nighttime display
«