DELTACALOR DIGITAL THERMOSTAT Manuel D'instructions page 13

The user can set the desired temperature on the device:
• Press the
• Set the desired temperature through the
temperature stops blinking.
EN
AUTOMATIC MODE
This operating mode allows the user to configure different temperature values for each
hour of each day of the week. The Comfort / Night temperatures and the related time
intervals can be thus programmed.
-To activate this function, press the
Programming the Automatic mode
a) Setting the current day of the week and time
• Enter into Stand-by mode and press the
least 3 seconds.
• On the upper part of the display the message Set will
be displayed.
• To set the day and time press the
bottom part of the display the message TED is dis-
played (see picture on the right).
• Press the
• The blinking arrow indicates the currently selected
day: Pressing the
can then be set.
• Press again the
for entering the time starts and the display shows the currently selected time.
• Hours: Use the
pressing the button.
• Minutes: Same procedure as for the hours. Confirm the selected value by pressing the
button.
• At the end of the procedure, the thermostat returns into Stand-by mode.
b) Setting the program for the Automatic mode
• Enter into Stand-by mode and press the
least 3 seconds.
• On the upper part of the display the message Set will
be displayed
• To set the day and time press the
bottom part of the display the message Prog is dis-
played (see picture on the right).
• Press the
• Now a time sequence can be defined for each day of
the week. The procedure starts with day 1, and the
desired sequence can be configured with the
day, it is then possible to assign either the Comfort temperature (full bar indication
displayed) by pressing the button or the Night temperature (empty bar) by pressing the
button (see picture below).
PROG button until the
PROG button to enter the editing mode.
and buttons the desired day
PROG button to confirm the selected day. After that, the procedure
and buttons to set the correct hour and confirm the selected value
PROG button to enter the editing mode.
Fil-Pilote icon is displayed.
and buttons and wait until the displayed
PROG button until the
button at
button until the
button at
button until the
and
13
Chrono icon is displayed.
buttons: for each hour of the