DELTACALOR DIGITAL THERMOSTAT Manuel D'instructions page 11

ICONS AND MODES OF THE THERMOSTAT
EN
Fil-Pilote
ON/STAND-BY
Press the
When activated, the bottom part of the display shows the current time, while the config-
ured operative mode and the temperature are shown in the upper part. When in Stand-by
mode current time, day of the week and the message: Stb are displayed.
NOTE - When the device goes into Stand-by mode it beeps twice for 0.5s.
When the device is activated it beeps once for 1s.
COMFORT
Two different levels of temperature can be set:
• COMFORT TEMPERATURE: it is the temperature used for Auto
Comfort
• NIGHT TEMPERATURE: it is the temperature used for the Night and Auto modes.
The range of configurable temperature is 7÷32°C.
IMPORTANT - The temperature of Night mode
temperature. For this reason the Night mode temperature can be set to a value between
7°C and the (configured Comfort mode temperature - 0.5°C). The temperature of Comfort
mode can be configured in the whole (Night temperature + 0.5°C) ÷ 32°C range.
Confort
ON/STAND-BY key to turn on the device or to enter the Stand-by mode.
Modalità Comfort
AND NIGHT
modes.
Night Anti-freeze
Modalità Stand-by
MODES
must be below to the Comfort
11
Timer 2 h Automatic
, Fil-Pilote and
mode