Humanscale M/FLEX Instructions De Montage page 7

STEP 9: M/FLEX CLAMP ADJUSTMENTS
Your M/Flex arrives ready for use, however it may become
necessary to adjust the clamp.
1. Remove monitors and links from the Bracket.
2. Open the Lever (A) all the way.
3. Turn the Adjustment Screw (B) clockwise ¼ of a turn using
the 3 mm hex key (C).
4. Test your adjustments by closing the Lever.
CAUTION: If the lever is difficult to close, or will not close
fully, it is over-tightened. Turn the Adjustment screw
counter-clockwise slightly.
Forcing it closed will damage the M/Flex.
STEP 10: WEIGHT ADJUSTMENTS
Your monitor should move up and down easily and stay in position.
If the monitor moves down from the desired position, or is hard to
lift, you should increase the counterbalance force. If the monitor
moves up from the desired position you should decrease the
counterbalance force.
1. Push the Upper Link (A) down until the Adjustment Screw (B)
is visible.
2. Using the appropriate hex key (4 mm for M2.1, 5 mm for M8.1)
turn the Adjustment Screw clockwise (towards + ) to increase
force, or counter-clockwise (towards – ) to decrease force.
Turn the Adjustment Screw (B) until the monitor is balanced.
3. Move the monitor around to ensure that the motion is
smooth and the arm holds the monitor in place.
NOTE: When installing several of the same monitors, note the
position of the needle in the indicator (C) on top of the arm.
Adjust the other arms to match.
CAUTION: Do not over-tighten the Adjustment Screw as it can
damage the Arm.
Monitors Should Not Exceed:
15.5 lbs (7 Kg) for M2.1
28 lbs (12.7 Kg) for M8.1
Total Weight Not To Exceed 60 lbs (27.2 Kg)
All manuals and user guides at all-guides.com
A
C
A
B
C
B
7