Publicité
Insu昀케cient air supply can cause poor draught and
thereby low combustion e昀케ciency and the problems this
entails: soot stains on the glass, ine昀케cient utilisation of
the wood and a soot deposits in the chimney.
Warning!
Keep combustion and convection air inlet free
from blockage.
Warrning! Extractor fans when operating
in the same room or space as the appliance
may cause problem.
Distance illustration (FIG 1 - 1B)
*The illustration indicates the approximate centre height
of the recess for the 昀氀ue. Consider possible inclination
of the 昀氀ue prior to making perforating the chimney.
Distortions in 昀氀oors and walls may also in昀氀uence the
height, dry stack therefore the 昀椀replace for accurate
height and positioning of the 昀氀ue/chimney connection.
If a fresh air supply set (accessory) is connected
through the 昀氀oor, mark where the hole should be.
Attention! Since the inner core is composed of
many layers the connection height may vary by up
to a few centimeters from installation to installation.
Safety distances (FIG 2 - 2B)
Ensure that the safety distances are complied with.
IMPORTANT! Drying Process
The 昀椀replace contains a lot of moisture when it is
new and no 昀椀re has been made before. This mois-
ture must be dried out before the 昀椀replace can
withstand the combustion rate given below.
To extract the moisture, follow this procedure:
1. Ensure that the air vent control just below the door is
completely open
2. Ensure that the damper is in ignition mode (FIG*).
3. Make a small 昀椀re with 0.5-1 kg of kindling wood
Attention! Let the air vent and damper remain open
until the 昀椀re is burnt out.
This procedure is repeated twice more, with a 24 hrs
gap between each time.
Attention! Failure to follow the guidelines for drying
can cause the elements to crack.
The air vent control is turned to the right to increase
the air supply to Salzburg R
A
-
Combustion pace
An accumulating 昀椀replace is designed to absorb thermal
energy during a relatively short period of relatively
intense heat. When the period of intensive combustion
is completed, the product will deliver the accumulated
heat over a longer period of time.
Attention! Combustion beyond the recommended
pace (see table with Technical Information) will
result in a higher surface temperatures, which
can lead to discoloration of the paint. It can also
result in higher than intended temperatures against
combustible walls.
Follow the values in the table to 昀椀nd the correct load
size and what loading interval is right for your product.
When the last load has passed into the ember phase
with few embers left, the air damper is closed
to prevent heat escaping through the chimney.
Remember to open the air damper before making a 昀椀re
in the 昀椀replace.
FIG *
The ignition mode should only be open during when
necessary for short periods (10-15 minutes) at the time
a 昀椀re is lit, and at new loads, in order to prevent smoke
or ash escaping into the room. Persistent combustion
with an open ignition mode can result in exceeding the
maximum allowed chimney temperature.
6. Assembly
Attention! It is very important that installation
instructions are read carefully and followed closely
in order to ensure optimal functioning of the
product.
GB
close
open
7
Publicité
