König Electronic SEC-ALARM200 Mode D'emploi page 3

Installation of Sensors - Batteries
Insert batteries in all the
sensors and mount them
accordingly. Please refer to the
User's Instructions for details
on how to install the Motion
Sensor and Door / Window
Sensor.
Operation - Alert Mode
All the sensors are preprogrammed at the factory, so the
Control Panel can communicate with these sensors after the
batteries are installed properly.
Door/Window Sensor
Activate the Door / Window Sensor, you will hear continuous
beeping, one beep at a time, indicating zone 1 sensor is
activated. Activate the other Door / Window Sensor, you will
hear continuous beeping, two beeps at a time, indicating
zone 2 sensor is activated.
Notes: The door/Window Sensor is factory default in zone 1
and zone 2.
Motion Sensor
To perform the walk test, its necessary to enable the Alert Zone (Bypass Zone) feature in the Control
Panel. After the walk test, it needs to disable this alert zone feature otherwise it will bypass the signal in
the alarm mode.
To enable the alert zone feature:
1. Press [PROG] + MPIN [factory default 1 2 3 4].
2. Press [8] to select Alert Zone.
3. Press [8] to enable for zone 3. The zone 3 LED will stay ON after selected.
4. Press [PROG] when finished.
Walk in front of the Motion Sensor, you will hear the continuous beeping from the Control Panel.
Beeping will continue for approx. 20 seconds for every motion detected.
To disable the alert zone feature:
1. Press [PROG] + MPIN [factory default 1 2 3 4].
2. Press [8] to select Alert Zone.
3. Press [3] to disable for zone 3. The zone 3 LED will flash after selected.
4. Press [PROG] when finished.
Notes:
1) The Motion Sensor is factory default in zone 3.
2) If the Motion Sensor doesn't respond to your movement, try not to move in front of the sensor for
20 seconds (i.e. no motion is detected in 20 seconds), then walk again. The Motion Sensor is
designed to be triggered only if no motion is detected for 20 seconds.
Program Emergency Phone Number
During an emergency, the Control Panel can call up to 5 phone numbers to inform you about an
emergency situation. There are 5 phone memories, it will first call phone memory 1, then phone
memory 2, etc. It will call phone memory 5 last. Each phone number can have a redial count up to
Remove the yellow
protective tag from
the sensors.
Beep
Activate the sensor
by opening the door,
you will hear voice
announcement and
continuous beeping.
3
Insert 9V alkaline
battery in the sensor
Close the door, and
beeping stop.