Power Fist 8011796 Mode D'emploi page 11

8011796
TROUBLESHOOTING
If the tool does not function properly or if it is missing parts, contact Princess Auto Ltd. for a solution. If
unable to do so, have a qualified technician service the tool.
Problem(s)
Tool runs at normal speed but
loses power under load.
Tool runs slowly. Air flows
slightly from exhaust.
Visit www.princessauto.com for more information
All manuals and user guides at all-guides.com
3/8 in. Right Angle Air Drill
Possible cause(s)
Motor parts worn.
Lack of air tool oil.
Motor parts jammed with
dirt particles.
OR
Air flow blocked by dirt.
Excessive air tool oil in tool.
Buildup of shipping grease.
Air Flow Regulator is in the
closed position
Suggested solution(s)
Have a qualified technician
replace worn parts.
Pour air tool oil into air inlet
per instructions.
1. Check air inlet filter
for blockage.
2. Pour air tool oil into air inlet
as per instructions.
3. Operate tool in short bursts.
4. Disconnect air supply.
Free motor by rotating
drive shank manually
where applicable.
5. Repeat above as needed.
If this fails, bring to
Princess Auto Ltd. or to a
qualified technician.
Run tool under no load for
short periods of time until
exhaust clears.
See Removing Packing
Grease section.
Open regulator to
correct position
V 2.7
11