Metabo TPS 14000 S Combi Instructions D'utilisation page 16

ENGLISH
switch, the pump does not switch ON:
send the pump to the service centre in
your country.
Motor hums, but does not start:
Pump blocked by foreign objects.

– Clean impeller.
Pump runs, but does not pump properly:
Delivery head too high.

– Observe max delivery head (see 'Tech-
nical Specifications').
Discharge hose kinked.

– Straighten discharge hose.
Discharge hose leaky.

– Seal discharge hose; tighten screw fit-
tings.
Pump runs very noisily:
Pump is sucking air.

– Ensure there is a sufficient water sup-
ply.
– Foreign objects are present (clean
pump).
– Manual mode has been set (shallow
water suctioning).
– Hold pump at an angle when submerg-
ing.
Pump runs continuously:
Float switch does not reach cut-out posi-

tion.
– Make sure the float switch can move
unrestrictedly.
8. Repairs
A
Danger!
Repair of power tools must be carried out by
qualified electricians only!
Power tools in need of repair can be sent to
the service centre in your country. Refer to
spare parts list for address.
Please attach a description of the fault to the
power tool.
9. Disposal
Power tools do not belong in the
household rubbish. According to
European Directive 2002/96/EC
on waste electrical and electronic
equipment, electrical waste must
be collected separately and taken
16
to an environmentally friendly recycling
facility.
Contact your local council for information on
disposal of the used tool.
All packaging materials are recyclable.