SFA Omega Lift Equipment MagicLift 29023B Manuel Des Consignes D'utilisation Et Des Pièces page 2

SAFETY AND GENERAL INFORMATION
Save these instructions. For your safety, read, understand, and follow the information provided with and on this
device before using. The owner and/or operator shall have an understanding of the device, its operating characteristics
and safety operating instructions before operating the equipment. The owner and/or operator shall be aware that use
and repair of this product may require special skills and knowledge. Instructions and safety information shall be read
to and discussed with the operator in the operator's native language, making sure that the operator comprehends
their contents, before use of this equipment is authorized. If any doubt exists as to the safe and proper use of this
device, remove from service immediately.
Inspect before each use. Do not use if abnormal conditions such as cracked welds, damaged, loose or missing
parts are noted. Any equipment that appears damaged in any way, is found to be worn, or operates abnormally shall
be removed from service until repaired. If the equipment has been or is suspected to have been subjected to an
abnormal load or shock, immediately discontinue use until inspected by a factory authorized repair facility (contact
distributor or manufacturer for list of authorized repair facilities). It is recommended that an annual inspection be
made by an authorized repair facility. Labels and Operator's Manuals are available from the manufacturer.
PRODUCT DESCRIPTION
This Hydraulic Service Jack is designed to lift, but not support, one end of a vehicle. Immediately after lifting, loads
must be supported by a pair of appropriately rated jack stands. MagicLift™ service jacks have a unique feature that
provides fast, no load lifts to the jacking point, at which time it lifts in approximately 1/4" ~ 3/4" increments.
WARNING: Never use a hydraulic jack as a stand-alone device. After lifting, immediately support the lifted
!
vehicle with a pair of appropriately rated jack stands.
Front Wheel
Saddle
Figure 1 - Service Jack Nomenclature
Handle
Lift Arm
Vent screw
(ref. Parts illustration
for location)
Rear Caster
2
Handle
Sleeve